Decking Calculator

Work out how many deck boards, joists and screws you need for a rectangular deck. Use your board size and the gap and joist spacing from your board maker’s instructions.

Want a full plan for the job? Try the Decking Planner. It asks a few questions and builds your shopping list, steps and supplier questions.

From the product. 144 mm is only an example.

From the product. 3.6 m is only an example.

Use the gap your board maker gives. 5 mm is only an example.

Use the maximum your board maker allows. Composite and thinner boards usually need closer joists. 400 mm is only an example.

A rule of thumb. Offcuts aren’t reused in this estimate.

Your estimate

Deck boards

47 boards

42 boards plus 10%.

Deck area
12 m²
Rows of boards
21 rows of 2 boards
Joists
11 joists, 3 m each (33 m in all)
Outer frame along the long sides
8 m
Deck screws
About 462A rule of thumb: two where each board crosses a joist.

Based on

  • A rectangular deck with boards running along its length
  • Board size, gap and joist spacing from you
  • No reuse of offcuts

Estimate only. Actual amounts vary with the product, ground conditions and how it’s laid.

How the calculation works

Rows of boards = the deck width divided by one board plus its gap. Each row needs the deck length divided by the board length, rounded up.

Joists run across the deck at your spacing, with one at each end. Screws are two per board per joist.

Rows = (width + gap) ÷ (board width + gap), rounded up
Boards = rows × (length ÷ board length, rounded up) + allowance
Joists = length ÷ spacing, rounded up, + 1
Screws = rows × joists × 2

Assumptions

  • Board sizes, the gap and joist spacing must come from your products. The defaults are only examples.
  • Offcuts are not reused, which slightly overestimates for decks shorter than a board.
  • Posts, footings, beams and fixings for a raised frame depend on the design and aren’t included.

Example: a 4 × 3 m deck, 144 mm boards 3.6 m long, 5 mm gap, joists at 400 mm

  1. Rows: (3 + 0.005) ÷ (0.144 + 0.005) = 20.2, so 21 rows.
  2. Each row is 4 m, so 2 boards per row: 42 boards, plus 10% = 47 boards.
  3. Joists: 4 ÷ 0.4 = 10, + 1 = 11 joists, each 3 m.

Useful tips

  • Where two boards meet end to end, the joint must land on a joist. Stagger the joints from row to row.
  • Seal the cut ends of treated softwood with an end-grain preservative.
  • Lay a weed-control membrane under the deck and leave space for air to flow under it.

Frequently asked questions

How far apart should decking joists be?

It depends on the boards. Use the maximum span your board maker gives; composite and thinner boards usually need closer joists.

How many screws do I need for decking?

A rule of thumb is two screws where each board crosses a joist.

Do I need planning permission for a deck?

Raised decks can need planning permission. Check with your council’s planning office before building one well above ground level.

Was this calculator helpful?