Paving Calculator

Find out how many paving slabs or blocks you need for a patio, path or driveway. Enter the area, the size of one slab or block, and the joint width.

Want a full plan for the job? Try the Patio & Paving Planner. It asks a few questions and builds your shopping list, steps and supplier questions.

For odd shapes, split the area into rectangles and add the results.

Check the laying guide for your product. Slabs usually have wider joints than block paving. Enter 0 to ignore joints.

Simple rectangles need less, and areas with curves, angles or a pattern need more. 10% is a rule of thumb.

Your estimate

Slabs or blocks to buy

About 60 units

Area to pave
20 m²
Area including allowance
22 m²
Units per m² (with joints)
2.69

Based on

  • 0.6 m × 0.6 m units
  • 10 mm joints
  • 10% extra for cuts and breakages

Estimate only. Actual amounts vary with the product, ground conditions and how it’s laid.

How the calculation works

Each slab covers its own size plus half a joint on each side. So the area per slab is (length + joint) × (width + joint).

The area to pave, plus an allowance for cutting and breakages, is divided by the area per slab and rounded up.

Area per unit = (length + joint) × (width + joint)
Units = ⌈area × (1 + allowance ÷ 100) ÷ area per unit⌉

Assumptions

  • All units are the same size. For mixed-size patio packs, use the coverage in m² given on the pack instead, and divide your area by it.
  • The 10 mm joint and 10% allowance are example values. Check your product’s laying instructions.
  • This counts the surface units only. Bedding (sand or mortar), sub-base, edging and jointing material are separate.

Example: a 5 m × 4 m patio with 600 × 600 mm slabs and 10 mm joints

  1. Area = 5 × 4 = 20 m². With 10% extra: 22 m².
  2. Area per slab = 0.61 × 0.61 = 0.3721 m².
  3. 22 ÷ 0.3721 = 59.1, rounded up = 60 slabs.

Useful tips

  • If you can, plan the patio size around whole slabs (including joints). This cuts down on cutting and waste.
  • Buy all the slabs from the same batch if possible, because colour can vary between batches.
  • Keep a few spare slabs for future repairs.

Frequently asked questions

How many 600 × 600 slabs are in a square metre?

Without joints, about 2.78 (1 ÷ 0.36). With 10 mm joints, about 2.69 per m².

How much extra paving should I order?

Many people add 5–10% for cuts and breakages, and more for curved or patterned layouts. You can change the allowance in the calculator.

Does this include the sub-base and sand?

No. It covers the slabs or blocks only. Use the Gravel or Concrete calculator for the layers underneath, depending on your design.

Was this calculator helpful?